Drop in your lap and a reference lap from the same track — get a synced side-by-side, racing-line map, pace & braking, and coaching.
01 · Your two laps
Telemetry · coaching from your logger (optional)
Trim · to the start/finish line
Scrub each clip to the start/finish line, then hit “Use current frame” (or fine-tune with −/+). Leave end at 0 to keep to the clip end. Optional — skip to compare the full clips.
02 · Comparison
Advanced
10 / s
Higher = smoother & more precise, but slower. ~10 is a good balance; 15 is the max.
One pocket-carried 6-axis IMU, nothing wired into the kart. Longitudinal g, lateral g and yaw rate are measured. Speed is solved from the cornering physics (v = a_lat / ω) and interpolated across the straights, and track distance is integrated from it — so read those two as shapes, not as readings. The trade buys a logger that needs no installation and works on an indoor track where GPS loggers are useless.
1 / 2
Not enough laps to compare
Lap comparison needs at least two complete laps. This session has one — either the run was short, or the start/finish line hasn’t been set yet, so ApexIQ can’t tell where one lap ends and the next begins.
Sync Lab · onboard video + telemetry replay
Upload an onboard video and the logger CSV from the same session — the camera pan is matched to the IMU yaw to sync them automatically (no GPS needed).
Replay · live telemetry overlay
-- km/h
IMU speed
Brake
Accel
Left
Right
—±1.5 g
--:--.-
telemetry time
no telemetry here
Scrub to the frame where you cross the start/finish line, then mark it — lap times are measured from there.